That’s About the Size of It

In Physics by Brian Koberlein20 Comments

Large radio telescopes are not solid dishes, but rather an open mesh. This is largely done to save on weight, since the dish doesn’t need to be solid to reflect radio waves. You see a similar thing on a microwave, where the door is covered with an open mesh so you can watch what’s cooking. The mesh blocks microwaves from reaching you, but not visible light. But how is that possible? Aren’t photons supposed to be point particles? Radio, microwaves are light, so how does a mesh prevent their photons from passing through it?

The short answer is it’s complicated. Although photons are often referred to as particles, they aren’t particles in the traditional sense. They are light quanta, which have both particle and wave properties. Depending on the situation, sometimes the particle aspect is useful, and sometimes the wave aspect is. While photons don’t have a physical diameter, and can be treated as point particles, their quantum behavior gives them a probabilistic size. As a photon gets closer to another object, the chance of it interacting becomes greater. This is often represented as a cross section given in terms of area.

Different cross sections vs energy for light with lead. Credit:  J. H. Hubbell

Different cross sections vs energy for light with lead. Credit: J. H. Hubbell

You could say the cross sectional area represents the “size” of a photon, but the problem with this is that a photon’s cross section varies depending on what it is interacting with. Photons interact pretty strongly with electrons, and have a relatively large cross section, but with neutrons the interaction is smaller. Under this definition there is no absolute “size” to a photon. The cross section also depends upon the energy of the photon and things like its polarization. There are also different cross sections for absorption vs scattering.

Despite all this complexity, there is a basic way to talk about the effective “size” of a photon, and that is through it’s wavelength. Very roughly, the interaction range of a photon scales with its wavelength, so light of longer wavelength is more likely to interact with a conductive material than light of a shorter wavelength. In this way you could say the “size” of photon is basically the width of its wavelength. The  wavelength of green light is about 500 nanometers, or two thousandths of a millimeter. The typical wavelength of a microwave oven is about 12 centimeters, which is larger than a baseball.

It’s a bit odd to think of a microwave photon as being larger than a baseball, but it is a simple way to explain how mesh reflectors work. The “size” of microwave and radio wave photons is simply too large to fit through the mesh, and so are reflected. Visible light is much smaller, so it easily passes through the mesh. It’s important not to take this model too literally, but it’s good enough for rough estimates.

And that’s about the size of it.


    1. think of a wave with this property: if ANY part of the wave hits a barrier, it will reflect. some things are barriers, some aren’t. you can even, if it’s easier, imagine it is physical. a string, for instance.

      now, look at the mesh in a microwave screen.

      a wave, or string, 2 thousandths of a millimeter can easily pass through the holes without any part hitting either side.

      a 12 centimeter string cannot.

      as the article says, this is actually not “correct” in the classical sense, but it does explain the action adequately for basic understanding.

    2. “Large radio telescopes are not solid dishes, but rather an open mesh. This is largely done to save on weight, since the dish doesn’t need to be solid to reflect radio waves”

      It is also done because (1) solid would be far more expensive (2) there is no need for solid (3) wind loading would be much different with a solid “dish” of this size…

  1. That’s the way I’ve always thought of it. Nice to know that I was on the right track!

  2. if by “wavelength” we refer to the distance between valley and valley on a light wave, then how about amplitude, the height of each valley and hill in the wave? How does the amplitude varies in light, and what effects does it has?

    1. OK, let me try… with a more possibly understood explanation (it’s as good as most !). Think about your car antenna. It is hit by trillions and trillions of photons each second. They (the photons) come in a wide range of energies (that energy level, as you know, is directly proportional to the resultant frequency.) Each “hit” causes an electron to start moving (a whole new, complex subject, but not too important here..)

      The resultant flow of electrons as it moves along… is a stupendous mix of energies…. of all sorts of “frequencies..” Energy and frequency are directly related. Somewhere, after the antenna is an electronic circuit that FILTERS OUT the frequencies/energies not wanted. (That is, you set the dial to radio station XXX, which is FM 91.1 on the tuner.) All the (the overwhelming majority…) of electrons NOT in a band straddling 91.1 megahertz… are routed to ground… You are tuned to the “band” licensed by a typical public radio station. NO mention of wavelength. !! no need for the term “wavelength…”

      So….. It takes a HIT of a photon ON an electron…to start the process, multiplied by trillions. Now… back to the mesh of the radio antenna.

      People often think that the WAVELENGTH is “larger” than the mesh, thereby “trapping” the radio signal. No. If the solid portion of the radio antenna is, say, 11% of the total area (the rest being air..), then the circuitry after the antenna utilizes only 11% of the photons ! Then the process goes on just like the description above of your car radio. The photons that do NOT hit the solid portion of the mesh simply fly by.

      Now…is that the ONLY explanation? No…if you read the above article, you will learn that, at this level and size of particle, both WAVE and PARTICLE aspects are present. I am sure the math would work out just as well if we emphasized the WAVE nature of photons.

      I just like this explanation better for antennas. Ask me about Polaroid filters…I give you a wavelength description,

      One last comment. We have image sensors for telescopes and cameras that can measure the impact of ONE photon! What do we measure?? We measure the IMPACT of the photon; the amount of energy it carries…(it is hard to imagine ONE bundle of energy actually possessing a wavelength) Now imagine TRILLIONS of photons all carrying the exact energy level. Hitting a piece of conducting metal, they will set up a movement of oscillating electrons, rushing through the circuitry. The most meaningful measurement of this oscillation….is a measurement of WAVELENGTH/FREQUENCY.

      Speed = Wavelength x Frequency (and…of course, in a vacuum, the speed is 300M meters/sec (lower in copper conductors)

  3. The font chosen on this blog means that quotes look like 9s and 6s, please change it! It’s doing my nut in. Otherwise, great write-up. Ta.

  4. Great writeup. Not an easy concept and I’m not sure the idea is cemented in my mind’s eye yet, but still very helpful.

    Small note: I think you’ve got the calculations slightly wrong on the green light. 500 nm would be half a thousandth of a millimeter. (Above you said it’s a couple thousandths, but that would be 2,000 nm.)

  5. “…500 nanometers, or two thousandths of a millimeter.” Should be reworded as “…500 nanometers, or one two-thousandth of a millimeter.” The way you have it stated it means 2000 nanometers.

    What you are trying to say is that (500nm X 2000 = 1mm) or (1/2000mm = 500nm) and instead you said that (2 X 1/1000mm = 500nm). 500 is not equal to 2000.

  6. Dear Brian,
    is our reality a simulation? I think it is. For instance, why does light have a max speed? Well, what if light moves 1 frame for each cycle of frame speed! Using D=RT and a frame is a Planck width a rate can be found.
    So then, what is TIME?
    It is the pressure we feel by this enormously preposterously fast recreation rate.
    Time Dilation then must be caused by the ‘catching up’ to that whatever (Higgs Field?) that turns the atoms on and off such that we peel away holographic layers from the recreated reality until at C, time stops.
    So, now, what say you to this view of our reality and the design rules that can manifest all the mystery of Quantum Physics and the Anthropic principles that amaze us all,
    Best wishes and go to my website for kids in hospitals ????
    We want more kids well faster!
    C. Smith

  7. What is the difference between ‘WHITE SUN LIGHT’ and ‘WHITE LED LIGHT’ ? Explain.

  8. This doesn’t explain what the resolution limit is for an optical microscope, or why electron microscopes can surpass that limit. Those are what I was wondering.

  9. Wave length is in the same direction of the movement of the wave. Size of the microwave mesh opening is in the transverse direction. How come a wavelength be the barrier to go through an opening in a transverse direction?

  10. A very interesting subject, when an object is and reflect color green iluminated with white light, the electrons in the object will reflect only the green part of the white light of the spectrum by going to a lower orbit around the nucleus, since this orbit is shorter the electron loose energy by emiting a green photon into space telling Us that the object is green.

Leave a Reply